Knowledgebase
Pre configured VPN router set up guide
Posted by Darren L on 05 June 2015 09:38 AM

                                                      How to Setup Your New VPN Router

 

 

Step-by-step Setup Instructions:

 

  1. Unbox your Mikrotik router, power cable and yellow CAT5 cable

  2. Take the CAT5 cable (pictured below) and plug one end into port 1 on the new Mikrotik router and the other end into a free LAN port on your own modem/router

     

     

  3. Plug in the power cable and power up the device, give it a few moments to connect

  4. On top of the new router you will find a sticker, which has the WiFi connection details on it. Use these to connect to your new VPN routers WiFi network

 

 

 

Important notes:

 

  • Never press the reset button on the device as it will remove our VPN setup and restore all factory defaults.

    If you do this the device will then be unusable, will need returned to, re-configured and again posted back to you. NOTE: all postage in this instance would be at the customers cost.

     

(13 vote(s))
This article was helpful
This article was not helpful

Comments (0)
Post a new comment
 
 
Full Name:
Email:
Comments:
Help Desk Software by Kayako fusion